| Peer-Reviewed

Research on the Transfer Characteristics of the Micro Particle in a Corrugated Pipe

Received: 21 June 2019     Published: 27 August 2019
Views:       Downloads:
Abstract

The corrugated pipe is widely used in figure heat exchangers. For the reason of large temperature difference between the gas in the pipe and the cold wall, particles may deposit on the wall, and make some adverse effects, such as poor cooling effect and the block in the pipe, especially in the pipe node. To solve the problem of deposition in the pipe, this paper will apply the model of DRW to calculate the trajectory of the micro particles. In this paper, the trajectories of particles with different sizes in a corrugated pipe are calculated, and the effects of structure parameter and inlet velocity on the trajectories of particles are studied. The conclusion can provide a theoretical basis for solving the deposition in corrugated pipes.

Published in International Journal of Economy, Energy and Environment (Volume 4, Issue 4)
DOI 10.11648/j.ijeee.20190404.12
Page(s) 71-79
Creative Commons

This is an Open Access article, distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution and reproduction in any medium or format, provided the original work is properly cited.

Copyright

Copyright © The Author(s), 2019. Published by Science Publishing Group

Keywords

Corrugated Pipe, Micro Particles, DPM Model

References
[1] Hinds, W. C. Properties, behavior, and measurement of airborne Particles [J]. Aerosol technology, 1984.
[2] Hidy, G. M. an industrial and environmental science [J]. Aerosols, 1984.
[3] Papavergos, P. G. & Hedley, A. B. Particle deposition behaviour from turbulence flows [J]. Chemical Engineering Research and Design, 1984, 62, 275-295.
[4] McLaughlin J. B. Aerosol particle deposition in numerically simulated channel flow [J]. Phys. Fluids A, 1989, 1 (7): 1211~1224.
[5] Fan, F. G. & Ahmadi, G. A sublayer model for turbulent deposition of particles in vertical ducts with smooth and rough surfaces [J]. Journal of Aerosol Science, 24, 45-64.
[6] Thakurta, D. G. Chen, McLaughlin J. B, Kontomaris K. Thermophoretic deposition of small particle in a direct numerical simulation of turbulent channel flow. International journal of heat and mass transfer [J] 1998, 41: 4167-4182.
[7] Gosman, A. D. Ioannides, E. Aspects of computer simulation of liquid fuelled combustors [J]. J. Energy 7, 482-490.
[8] Kallio G. A., Reeks M. W. A numerical simulation of particle deposition in turbulent boundary layers [J]. International Journal of Multiphase Flow, 15 (3): 433-446.
[9] Hao Lu, Lin Lu. Numerical investigation on particle deposition enhancement in duct air flow by ribbed wall [J]. Building and Environment, 2015, 85: 61-72.
[10] Bai Zhenxiao. Analysis of the Diesel Exhaust Particle Transport and Deposition in Turbulent Flow [D]. Beijing: Beijing Jiaotong University, 2011.
[11] A. D. Gosman, E. Ioannides. Aspects of computer simulation of liquid-fuelled combustors. [J]. Energy, 1983, 7 (6): 482–490.
[12] L. Talbot et al. Thermophoresis of Particles in a Heated Boundary Layer. [J]. Fluid Mech, 1980, 101 (4): 737–758.
[13] P. G. Saffman. The Lift on a Small Sphere in a Slow Shear Flow. [J]. Fluid Mech, 1965, 22: 385–400.
[14] A. Li, G. Ahmadi. Dispersion and Deposition of Spherical Particles from Point Sources in a Turbulent Channel Flow. [J]. Aerosol Science and Technology, 1992, 16: 209–226.
[15] Q. Zhou and M. A. Leschziner. Technical report [C]// 8th Turbulent Shear Flows Symp, Munich. 1991.
[16] Matida Edgar Akio, Nishino Koichi, Torii Kahoru. Statistical simulation of particle deposition on the wall from turbulent dispersed pipe flow [J]. International Journal of Heat and Fluid Flow, 2000, 21 (4): 389-402.
[17] B. J. Daly and F. H. Harlow. Transport Equations in Turbulence [J]. Phys. Fluids. 1970, 13: 2634–2649.
[18] Zhang Z, Chen Q. Prediction of particle deposition onto indoor surfaces by CFD with a modified Lagrangian method [J]. Atmospheric Environment, 2009, 43 (2): 319-328.
[19] Zhang Jinping, Li Angui, Li Desheng. Modeling deposition of particles in typical horizontal ventilation duct flows [J]. Energy Conversion and Management, 2008, 49 (12): 3672-3683.
[20] Fan, F. G. & Ahmadi, G. A sublayer model for turbulent deposition of particles in vertical ducts with smooth and rough surfaces [J]. Journal of Aerosol Science, 2007, 24: 45-64.
Cite This Article
  • APA Style

    Ding Yu, Ning Zhi, Lü Ming. (2019). Research on the Transfer Characteristics of the Micro Particle in a Corrugated Pipe. International Journal of Economy, Energy and Environment, 4(4), 71-79. https://doi.org/10.11648/j.ijeee.20190404.12

    Copy | Download

    ACS Style

    Ding Yu; Ning Zhi; Lü Ming. Research on the Transfer Characteristics of the Micro Particle in a Corrugated Pipe. Int. J. Econ. Energy Environ. 2019, 4(4), 71-79. doi: 10.11648/j.ijeee.20190404.12

    Copy | Download

    AMA Style

    Ding Yu, Ning Zhi, Lü Ming. Research on the Transfer Characteristics of the Micro Particle in a Corrugated Pipe. Int J Econ Energy Environ. 2019;4(4):71-79. doi: 10.11648/j.ijeee.20190404.12

    Copy | Download

  • @article{10.11648/j.ijeee.20190404.12,
      author = {Ding Yu and Ning Zhi and Lü Ming},
      title = {Research on the Transfer Characteristics of the Micro Particle in a Corrugated Pipe},
      journal = {International Journal of Economy, Energy and Environment},
      volume = {4},
      number = {4},
      pages = {71-79},
      doi = {10.11648/j.ijeee.20190404.12},
      url = {https://doi.org/10.11648/j.ijeee.20190404.12},
      eprint = {https://article.sciencepublishinggroup.com/pdf/10.11648.j.ijeee.20190404.12},
      abstract = {The corrugated pipe is widely used in figure heat exchangers. For the reason of large temperature difference between the gas in the pipe and the cold wall, particles may deposit on the wall, and make some adverse effects, such as poor cooling effect and the block in the pipe, especially in the pipe node. To solve the problem of deposition in the pipe, this paper will apply the model of DRW to calculate the trajectory of the micro particles. In this paper, the trajectories of particles with different sizes in a corrugated pipe are calculated, and the effects of structure parameter and inlet velocity on the trajectories of particles are studied. The conclusion can provide a theoretical basis for solving the deposition in corrugated pipes.},
     year = {2019}
    }
    

    Copy | Download

  • TY  - JOUR
    T1  - Research on the Transfer Characteristics of the Micro Particle in a Corrugated Pipe
    AU  - Ding Yu
    AU  - Ning Zhi
    AU  - Lü Ming
    Y1  - 2019/08/27
    PY  - 2019
    N1  - https://doi.org/10.11648/j.ijeee.20190404.12
    DO  - 10.11648/j.ijeee.20190404.12
    T2  - International Journal of Economy, Energy and Environment
    JF  - International Journal of Economy, Energy and Environment
    JO  - International Journal of Economy, Energy and Environment
    SP  - 71
    EP  - 79
    PB  - Science Publishing Group
    SN  - 2575-5021
    UR  - https://doi.org/10.11648/j.ijeee.20190404.12
    AB  - The corrugated pipe is widely used in figure heat exchangers. For the reason of large temperature difference between the gas in the pipe and the cold wall, particles may deposit on the wall, and make some adverse effects, such as poor cooling effect and the block in the pipe, especially in the pipe node. To solve the problem of deposition in the pipe, this paper will apply the model of DRW to calculate the trajectory of the micro particles. In this paper, the trajectories of particles with different sizes in a corrugated pipe are calculated, and the effects of structure parameter and inlet velocity on the trajectories of particles are studied. The conclusion can provide a theoretical basis for solving the deposition in corrugated pipes.
    VL  - 4
    IS  - 4
    ER  - 

    Copy | Download

Author Information
  • School of Mechanical, Electronic and Control Engineering, Beijing Jiaotong University, Beijing, China

  • School of Mechanical, Electronic and Control Engineering, Beijing Jiaotong University, Beijing, China

  • School of Mechanical, Electronic and Control Engineering, Beijing Jiaotong University, Beijing, China

  • Sections